Ryobi RBC18X20B4 Traduction Des Instructions Originales page 3

Safety, performance, and dependability have
been given top priority in the design of your
cordless line trimmer and brushcutter.
INTENDED USE
The line trimmer/brushcutter is intended to
be used only by adults who have read and
understood the instructions and warnings in
this manual and can be considered responsible
for their actions. This product is only intended
for use outdoors in a well ventilated area.
For safety reasons, the product must be
adequately controlled by using two-handed
operation.
When fi tted with the line trimmer head (and
appropriate guard), the product is intended
for cutting long grass, pulpy weed, and similar
vegetation at or about ground level. When
fi tted with the TRI-ARC blade (and appropriate
guard), it can also cut bushes.
The cutting plane should be approximately
parallel to the ground surface. The product
should not be used to cut or trim hedges,
bushes, or other vegetation where the cutting
plane is not parallel to the ground surface.
WARNING
When using the product, the safety rules
must be followed. For your own safety
and that of bystanders, please read these
instructions before operating the product.
Please keep the instructions safe for later
use.
WARNING
The product is not intended to be used by
children or persons with reduced physical,
mental or sensory capabilities.
Children should be supervised to ensure
that they do not play with the appliance.
TRAINING
■
Never allow children or people unfamiliar
with the instructions to use the product.
■
Read the instructions carefully. Be familiar
with all controls and the proper use of the
product.
■
Keep the area clear of all bystanders,
children and pets while trimming. Stop the
product if anyone enters the area.
■
Never operate the product when you are
tired, ill or under the influence of alcohol,
drugs, or medicine.
■
Use the product for cutting grass and
light weeds only. Do not use for any other
purpose.
■
Keep in mind that the operator or user
is responsible for accidents or hazards
occurring to other people or their property.
PREPARATION
■
Wear full eye and hearing protection while
operating the product. If working in an area
where there is a risk of falling objects, head
protection must be worn.
■
Hearing protection
operator's ability to hear warning sounds
■
Pay particular attention to potential hazards
around and inside the work area.
■
Wear heavy long trousers, boots, and
gloves. Do not wear loose fitting clothing,
short trousers, jewellery of any kind, or use
with bare feet.
■
Secure long hair so it is above shoulder
level to prevent entanglement in moving
parts.
■
Before use and after any impact, check that
there are no damaged parts. A defective
switch or any part that is damaged or worn
should be properly repaired or replaced by
an authorised service facility.
■
Make sure the cutting attachment is
properly installed and securely fastened.
■
Never operate the product unless all
guards, deflectors and handles are properly
and securely attached.
■
Consider the environment in which you are
working. Keep the working area free from
wires, sticks, stones and debris, which if
struck by the cutter, can become thrown
objects.
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
may restrict the HR
SL
SK
BG
UK
TR
English |
1