Ribimex PRBAT20 Manuel D'instructions Et D'utilisation page 31

3.6- In the event of emergency
Stop immediately the tool and remove the battery.
Assist the injured person with first aid and call for medical assistance as quickly as possible.
If electrolyte leaks and contacts skin or eyes, rinse thoroughly with clean water and seek immediate
medical attention.
IV. GETTING STARTED
Warning! The tool must NOT be used or switched on until it has been fully assembled.
WARNING: IF ANY PART IS MISSING OR DAMAGED, DO NOT OPERATE THE
MACHINE UNTIL YOU HAVE REPLACED THE MISSING OR DAMAGED PART.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damaged.
4.2- Assembly
The tool requires some assembly prior to first time use.
4.2.1- Brush cutting head
1. Fix the brush cutter safety guard into gear case with three bolts by using hex wrench (Fig. 2A).
NOTE: To avoid of reverse assembling. Please follow Fig. 2G.
2. Install the lower blade retainer on safety guard and insert the hex wrench into the hole of lower
blade retainer to fix the machine (Fig. 2B).
Note: The hex wrench should be inserted inside the hole till whole assembling done.
3. Install the blade onto lower blade retainer (Fig. 2C).
NOTE: Remember the marks on blade should be faced to the lower blade retainer.
4. Install the upper blade retainer on the blade (Fig. 2D)
5. Install the protection cup to cover the upper blade retainer (Fig. 2E).
6 Tighten the nut (turn anticlockwise) by using a socket hex wrench (Fig. 2F)
Fig. 2A Fig. 2B Fig. 2C
Fig. 2D Fig. 2E Fig. 2F
Page 31 / 62