Unimac UDE807F Directives D'installation Et De Fonctionnement page 39

can be reinstalled inside the control hood of your unit. Refer to
instructions below for installation.
1. Remove the Phillips head screw from service door (refer to
Figure 39 ).
2. Remove two screws holding control panel to control hood.
3. Tilt control panel forward and lay on a protective pad to pre-
vent scratching of cabinet top.
4. Insert Phillips head screw down through double "D" hole in
left rear corner of cabinet top (inside control hood) until it en-
gages retainer nut located on left rear corner gusset of cabinet.
5. Finger tighten screw.
IMPORTANT: Do not use a power driver to tighten
screw. Torque of a power driver could over-tighten
screw causing damage to cabinet assembly.
1
1. Double "D" Hole
Figure 39
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
39
Installation
Part No. D512681ENR9