8. Using screwdriver, remove two door plugs, and reinstall on
opposite side of door opening.
9. Reinstall four hinge attaching screws, removed in Step 1.
Wipe Out Inside of Dryer
Before using dryer for the first time, use an all-purpose clean-
er, or a detergent and water solution, and a damp cloth to re-
move shipping dust from inside dryer drum.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
DRY1919N_SVG
Figure 16
D620I_SVG
Figure 17
D623I_SVG
Figure 18
Plug In the Dryer
Electric Dryers with 4-Wire Plug (Supplied with
Dryer)
120/240 Volt, 60 Hertz, 3-Wire and Earth/Ground Installation
120/208 Volt, 60 Hertz, 3-Wire and Earth/Ground Installation
NOTE: The wiring diagram is located in the control
hood.
To reduce the risk of fire, electric shock, serious in-
jury or death, all wiring and protective earth/ground
connections MUST conform with the latest edition of
the National Electrical Code, ANSI/NFPA 70, or the
Canadian Electrical Code, CSA C22.1, and such local
regulations as might apply. It is the customer's re-
sponsibility to have the wiring and fuses installed by
a qualified electrician to make sure adequate electri-
cal power is available to the unit.
Earth/Ground and Wiring Instructions
This appliance must be properly connected to protective earth/
ground. In the event of malfunction or breakdown, the earth/
ground will reduce the risk of electric shock by providing a path
of least resistance for electric current.
This appliance is equipped with a cord having an equipment-
earth/ground conductor and an earth/ground plug. The plug must
be plugged into an appropriate outlet that is properly installed and
connected to a protective earth/ground in accordance with all lo-
cal codes and ordinances.
23
D618I_SVG
Figure 19
WARNING
Part No. D512681ENR9
Installation
W891