Additional Dryer Security - Unimac UDE807F Directives D'installation Et De Fonctionnement

Installation
1
1. Spring Installed
2. Extension Bracket and Lever Assembly
3. Coin Slide Bracket - Letter "A"
6. Install coin slide extension assembly onto top of coin slide us-
ing two remaining screws and lockwashers. Place lockwasher
under head of screws, above bracket "A". Refer to Figure 37 .
1. Coin Slide Extension Assembly
2. Spring Installed
7. Before installing coin slide and extension, make sure ground
wire is tucked under control shield to provide clearance for
coin slide. Refer to Figure 38 .
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
2
3
TLW2163N_SVG
Figure 36
1 2
TLW2164N_SVG
Figure 37
1. Ground Wire Placement
Installing Extension Onto Coin Slide: Option 1
1. Insert coins and partially extend coin slide.
2. Insert coin slide on its side through meter case opening. Then
rotate 90 degrees to its proper orientation.
3. Return coin slide and hook slide pins onto meter case.
4. Continue coin slide installation according to manufacturer's
instructions.
5. Check to make sure coin slide is operating properly by insert-
ing coins and starting a cycle. The IN USE light will turn on,
or flash if it is already on, to indicate proper operation.
NOTE: To avoid long run-down time (45 minutes fac-
tory default) when testing operation, refer to Test
Setting section.
Installing Extension Onto Coin Slide: Option Two
1. Install coin slide according to manufacturer's instructions.
2. Insert coins into coin slide and slowly push slide in. Stop be-
fore coins fall into coin box. This will allow installing exten-
sion through meter case service door opening.
3. Install slide extension onto top of coin slide using two screws.
Refer to Figure 37 .
4. Check to make sure coin slide is operating properly by insert-
ing coins and starting a cycle. The IN USE light will turn on,
or flash if it is already on, to indicate proper operation.
NOTE: To avoid long run-down time (45 minutes fac-
tory default) when testing operation, refer to Test
Setting section.

Additional Dryer Security

Located on the service door of meter case models is a flat Phillips
head screw. During shipment, this screw is used to attach the
service door to the meter case. For additional security, this screw
38
1
TLW2157N_SVG
Figure 38
Part No. D512681ENR9