To Convert From 4-Wire Connection To 3-Wire Connection - Unimac UDE807F Directives D'installation Et De Fonctionnement

Installation
2
3
1. A typical 30-Amp Three-Wire Receptacle NEMA Type 10-30R
2. 120 ± 12 V.A.C.
3. 240 ± 12 V.A.C.
4. Intermediate Fuse Box (may be omitted if service entrance box is fused)
5. Wall Receptacle
6. Power Supply
7. 3-Wire Earth/Ground Neutral 120/240 Volt, 60 Hertz AC 1 Phase Service Entrance Switch Box (Refer to NOTE above)
8. 30 Ampere Fuses or Circuit Breaker
9. Neutral Wire
10. Metallic or Non-Metallic Sheathed Cable (Copper Wire Only)
11. Pigtail to Dryer (Refer to NOTE above)
12. Neutral
13. Terminal Block in Dryer
14. Intermediate Shut-Off Box (may or may not be fused)
15. Direct Connection
16. Pigtail Connection
To Convert from 4-Wire Connection to 3-Wire
Connection
1. Disconnect power to dryer.
2. Remove access cover from rear of dryer.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
1
4
5
2
16
6
7
8
9
10
11
12
13
L1 L2
15
Figure 21
26
14
L1 L2
D816I_SVG
D695I_SVG
Figure 22
Part No. D512681ENR9