Unimac UDE807F Directives D'installation Et De Fonctionnement page 36

Installation
1
9
8
1. Spring
2. Bolt
3. One or Two Flat Washers (Shims)
4. Rounded Corner
5. Nut
6. Extension Lever
7. Star(s) Facing Down
8. Extension Bracket
9. Loops
5. Torque nut between 18 and 20 inch-pounds 2 and 2.26 Nm, or
tighten nut firmly.
6. Install extension spring in bracket hole and hole in upper arm
of lever. Refer to Figure 31 .
7. Bend loops closed after installation.
8. Check to make sure the lever swings freely.
Installing Extension Onto Coin Slide: Option One
1. Install slide extension onto top of coin slide using two re-
maining screws and lockwashers. Refer to Figure 32 .
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
2 3
4
6
7
TLW2089N_SVG
Figure 31
5
4
1. Lockwashers
2. Attaching Screws
3. Slide Extension
4. Coin Slide
2. Insert coins and partially extend coin slide.
3. Insert coin slide on its side through meter case opening. Then
rotate 90 degrees to its proper orientation.
4. Return coin slide and hook slide pins onto meter case.
5. Continue coin slide installation according to manufacturer's
instructions.
NOTE: During coin slide installation, make sure acti-
vation lever is up and off the switch. Refer to Figure
33 .
36
2
1
3
TLW1564K_SVG
Figure 32
Part No. D512681ENR9