Slide Extension Assembly - Unimac UDE807F Directives D'installation Et De Fonctionnement

1. Lever Off Switch
6. Check to make sure coin slide is operating properly by insert-
ing coins and starting a cycle. The IN USE light will turn on,
or flash if it is already on, to indicate proper operation.
NOTE: To avoid long run-down time (45 minutes fac-
tory default) when testing operation, refer to Test
Setting section.
Installing Extension Onto Coin Slide: Option Two
1. Install coin slide according to manufacturer's instructions.
2. Insert coins into coin slide and slowly push slide in. Stop be-
fore coins fall into coin box. This will allow installing exten-
sion through meter case service door opening.
3. Install slide extension onto top of coin slide using two screws
and lockwashers. Refer to Figure 1.
NOTE: Make sure extension lever is above switch
activation lever.
4. Check to make sure coin slide is operating properly by insert-
ing coins and starting a cycle. The IN USE light will turn on,
or flash if it is already on, to indicate proper operation.
NOTE: To avoid long run-down time (45 minutes fac-
tory default) when testing operation, refer to Test
Setting section.

Slide Extension Assembly

1. Remove slide extension parts from parts accessories bag in-
cluded in unit.
2. Install extension lever with arm that has one star facing down.
Refer to Figure 34 .
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
1
TLW2090N_SVG
Figure 33
1. One Star
3. Install extension lever with rounded corner facing away from
extension bracket using shoulder bolt, flat washer and nut.
Refer to Figure 35 .
4. Install spring to extension bracket with hook facing down. In-
stall other end of spring to extension lever with hook facing
left while standing in front of unit. Refer to Figure 35 .
1
7
1. Shoulder Bolt
2. Spring
3. Flat Washer
4. Rounded Corner
5. Nut
6. Extension Lever
7. Extension Bracket
5. Install extension bracket and lever assembly onto coin slide
bracket using two screws and locknuts. Refer to Figure 36 .
IMPORTANT: Install coin slide bracket with side
marked "A" facing up and toward extension bracket
and lever assembly. Refer to Figure 36 .
37
1
TLW2160N_SVG
Figure 34
2
3
6
TLW1610K_SVG
Figure 35
Part No. D512681ENR9
Installation
4
5