Vending; Meter Case; Coin Slide Control - Unimac UDE807F Directives D'installation Et De Fonctionnement

Installation
Shut-off Valve Only Applicable on Certain Models
1. Air Shutter Lockscrew
2. Air Shutter
3. 3.1 mm [1/8 in.] Pipe Plug (For checking manifold pressure)
4. Shut-off Valve Open Position
5. Shut-off Valve Closed Position
6. Shut-off Valve Handle

Vending

Meter Case

Metered Models
The factory mounted coin meter case does not include the service
door lock, coin drawer, coin drawer lock or keys. These parts
must be ordered (at extra cost) according to the purchaser's re-
quirements direct from the manufacturer of your choice.
NOTE: You have the option of using a screw type lock
or a 1/4 turn lock on the meter case service door. If you
choose to use a screw lock, then the special bracket
(located inside the meter case) must be used. DO NOT
use the special bracket if a 1/4 turn lock is used.
Coin Drawer Security - For additional security, drill out the two
pilot holes on each side of the front of the meter case to 6.4 or 7.9
mm [1/4 or 5/16 inch] holes and install a bicycle lock through
these holes.

Coin Slide Control

Power-Up Mode
When power is applied to the dryer, the control will enter the
Ready Mode. If the control was powered down during a running
a cycle, the IN USE LED will flash once and the control will en-
ter Start Mode. If the dry time dipswitch settings have not been
changed from factory default, the IN USE LED will flash once.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
5
4
3
1
6
Figure 28
Ready Mode
In Ready Mode, the control waits for the vend to be satisfied be-
fore entering Start Mode.
Start Mode
In Start Mode, the vend has been satisfied, but the Start button
has not been pressed. The IN USE LED will be lit. The timer will
not count down until the Start button is pressed.
Run Mode
In Run Mode, the control is running a cycle. The IN USE LED is
lit.
Door Open Mode
In Door Open Mode, the control turns off the heater and motor
when the door is opened during a run cycle. The timer will con-
tinue to count down time and the IN USE LED is lit.
End of Cycle Mode
In End of Cycle Mode, a cycle is complete and the IN USE LED
is off. The control remains in this mode until the door is opened
or additional vend has been satisfied.
Top-Offs
Any time the control receives a coin slide pulse during a cycle it
will add the programmed dry time to the time currently remaining
in the cycle. The IN USE LED will flash briefly to indicate the
coin input. The maximum cycle time is 99 minutes. The control
30
2
DRY2753N_SVG
Part No. D512681ENR9