Cleaning And Maintenance; Cleaning; Inserting/Changing The Batteries - VOLTCRAFT LSG-10 Notice D'emploi

Cleaning and Maintenance

General
Apart from occasional cleaning and battery replacements, the cable detector requires no servicing.
The battery change is described below.
Regularly check the technical safety of the instrument and measuring leads, e.g.
check for damage to the housing or squashing etc.

Cleaning

Always observe the following safety instructions before cleaning the device:
Live components may be exposed if covers are opened or parts are removed (unless
this can be done without tools).
The connected lines must be disconnected from the measuring device and all mea-
suring objects prior to cleaning or repairing the device. Switch the device off.
Do not use any carbon-containing cleaning agents or petrol, alcohol or the like to clean the product. These
could corrode the surface of the meter. Furthermore, the fumes are hazardous to your health and explosive.
Moreover, you should not use sharp-edged tools, screwdrivers or metal brushes or similar for cleaning.
When cleaning the device or the display and the measuring lines, use a clean, lint-free, antistatic, slightly
damp cloth. Allow the product to dry completely before you use it again to conduct measurements.
Inserting and Changing the Batteries
Operation of the device requires a 9V battery (e.g. 1604A). You need to insert a new, charged battery prior
to initial operation or when the battery change symbols appear on the display.
Proceed as follows to insert or change the batteries:
- Separate the connected measuring lines from the measuring circuit and the measuring device. Switch
off the device.
- Open the battery compartment on the rear.
- Replace the flat batteries with new one of the same type. Place a new battery into the battery com-
partment (11 or 17), observing the correct polarity. Observe the correct polarity indicated in the battery
compartment.
- Now, close the housing carefully.
46