Installing The Software; Cleaning And Maintenance; General Information; Cleaning - VOLTCRAFT LCR-400 Mode D'emploi

11. INSTaLLINg ThE SofTwaRE

1. Insert the CD into your computer's CD-ROM drive.
2. The installation will start automatically. If it does not, go to the CD-ROM directory and locate and run the installa-
tion file "autorun.exe".
3. Follow the instructions displayed in the dialog box, select the destination folder for the installation and carry out
the installation.
4. Please refer to the operating instruction included on the CD for further details.
Get the latest voltsoft updates from "http://www.conrad.com".

12. CLEaNINg aND MaINTENaNCE

a) general information
To ensure accuracy of the multimeter over an extended period of time, it should be calibrated once a year in a
calibration lab.
Apart from occasional cleaning and battery replacements, the meter requires no servicing. Notes on replacing the
battery are provided below.
Regularly check the technical safety of the device and measuring lines, e.g. check for damage to
the casing or squeezing, etc.
b) Cleaning
Always observe the following safety information before cleaning the device:
Live components may be exposed if covers are opened or parts are removed (unless this can be
done without tools). The connected lines must be disconnected from the meter and all measuring
objects before the device is cleaned or repaired. Switch off the device.
Do not use any carbon-containing cleaning agents or petrol, alcohol or the like to clean the product. They will dam-
age the surface of the meter. Furthermore, the fumes are hazardous to your health and explosive. Also do not use
any sharp-edged tools, screwdrivers, metal brushes, etc. for cleaning.
Use a clean, lint-free, antistatic, slightly damp cloth for cleaning the device or the display and the measuring lines.
Allow the product to dry completely before you use it again to conduct measurements.
44