Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Product symbols
In this manual and/or on the machine the following symbols are used. These
represent important information about the product or instructions on its use.
1300 W
Rated output
1300W
230-240 V~ 50 Hz
Rated voltage
230-240 V~
50Hz
5500 /min
min
-1
No load speed
5500
Blade size : Ø 190mmX
Ø 16mmX24T
Ø 190mm X Ø 16mm
X24T
With a dust extraction
adaptor to suction the
dust
180731_ayce_3285_IM
0-45°bevel
adjustment
66 mm cutting
capacity at 90°
66mm
3m cable with Swiss
plug
3M
With a laser function
for more precise
cutting
OPERATION
1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the machine and your
purpose.
2. Functions
a. Adjust the cutting depth (Fig. 1)
!
Always ensure that the saw is switched off and unplugged from the
power supply before making any adjustments.
WARNING
Fig. 1
NOTE: Always use the correct blade depth setting. The correct blade depth setting for
all cuts should not be more than a full tooth of the blade teeth below the material being
cut. Allowing more depth will increase the chance of kickback and result in a rough
cut.
98 99
|
•
Ensure that the saw is facing away
from you.
•
Loosen the depth locking lever. Hold
the base plate flat against the edge
of the work piece and lift the body
of the saw until the blade is at the
right depth. Use the depth scale to
determine the cutting depth.
•
Tighten the depth locking lever.
180731_ayce_3285_IM
GB
Publicité
Table des Matières
