Ayce 3285 Manuel D'utilisation page 53

!
Never use the product for a plunge cut.
WARNING
• Mark the line of cut on the work piece.
• Adjust the depth of cut and bevel angle as required.
• When making 90° cross or rip cuts, align your line of cut with the outer blade guide
notch on the base of the saw.
• When making 45° bevel cuts, align your line of cut with the inner blade guide notch
on the base of the saw.
• Rest the front edge of the base on the work-piece. Make sure the power cord is out
of the way of saw the blade and not in the line of cut.
• Start the motor by depressing the lock-off button and squeezing the trigger switch.
NOTE: Always let the blade reach full speed before you begin to cut into the work-
piece.
• Slowly push the saw forward using both hands. Apply downward pressure to keep
the saw steady and only enough forward pressure to keep the blade cutting.
• When making a cut always use steady, even pressure. Forcing the saw causes
rough cuts and could shorten the life of the saw or cause kickback. Allow the blade
and the saw to do the work.
• After completing your cut, release the trigger switch and allow the blade to come
to a complete stop. Do not remove the saw from the work-piece while the blade is
moving.
NOTE: Since blade thickness varies, always make a trial cut in scrap material along
the guideline to determine how much, if any, the guideline must be offset to get an
accurate cut.
!
Keep all parts of your body away from the blade after operated, the
blade will be very hot.
WARNING
NOTE: Vacuum cleaner must be connected before cutting.
180731_ayce_3285_IM
MAINTENANCE
CAUTION!
Always disconnect the device before performing any adjustment or maintenance
operation. If the supply cord is damaged, it must be replaced by the manufacturer or
its service agent in order to avoid a hazard.
Disconnect from the power supply immediately if the supply cord is damaged.
Take care not to expose this tool to the rain.
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
STORING
Store the machine, operating instructions and where necessary the accessories in the
original packaging. In this way you will always have all the information and parts ready
to hand. Pack the device well or use the original packaging in order to avoid transit
damage. Always keep the machine in dry place.
DISPOSAL
Do not dispose of power tools into household waste! According the
European Guideline 2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national right, power tools that
are no longer usable must be collected separately and disposed of in an
environmentally correct manner.
104 105 |
GB
180731_ayce_3285_IM