Ayce 3285 Manuel D'utilisation page 51

b. Adjust the bevel angle (Fig. 2)
Always ensure that the saw is switched off and unplugged from the
!
power supply before making any adjustments.
WARNING
Fig. 2
NOTE: Always make a trial cut in a scrap piece of material along a guideline to
determine how much you should offset the blade from the guideline to make an
accurate cut.
c. Using the parallel fence (Fig. 3)
Always ensure that the saw is switched off and unplugged from the
!
power supply before making any adjustments.
WARNING
Fig. 3
180731_ayce_3285_IM
• The saw can be adjusted to cut at any
angle between 0° and 45°. When
making 0° and45° bevel cuts, there is
a notch in the saw base to help you
line up the blade with the line of cut.
Align your line of cut with the inner
blade guide notch on the base of the
saw when making 45° bevel cuts.
• Loosen the bevel locking knobs
located at the front and back of the
base plate. Tilt the body of the saw
until the required angle is reached
using the bevel scale as a guide.
• Tighten the bevel locking knobs to
secure the base plate.
• The parallel fence allows you to make
parallel cuts in a sheet of wood, all at
the same width.
• Loosen the parallel fence locking knob.
• Slide the parallel fence through the
parallel fence slots in the base plate.
• Adjust the parallel fence to the
required width and secure it in position
with the parallel fence locking knob.
• Ensure that the parallel fence rests against the wood along its entire length to give a
consistent parallel cut.
d. Using the laser (Fig. 4)
! Before proceeding to use the laser line system, ensure that the
Additional Safety Rules for Laser Lights section is read and fully
understood.
WARNING
Fig. 4
100 101 |
• Always ensure the laser beam is aimed
at a sturdy work-piece without
reflective surfaces. i.e. wood or rough
coated surfaces are acceptable. Bright
shiny reflective sheet steel or the like
is not suitable for laser use as the
reflective surface could direct the
beam back at the operator.
• Only turn the laser beam on when the
tool is on the work-piece.
• Mark the line of the cut on the work-
piece.
• Adjust the depth of cut and bevel angle
as required.
• Rest the front edge of the base on the
work-piece.
• Push the laser light on/off button to "I"
position to switch on the laser beam.
• Align the beam with the line on the
work-piece.
• Start the motor and always let the
blade reach full speed before you begin
to cut into the work piece.
• Slowly push the saw forward using
both hands, keeping the red laser light
beam on the line of cut.
• After completing your cut, release the
trigger switch and allow the blade to
come to a complete stop.
• Do not remove the saw from the work-
piece while the blade is moving.
180731_ayce_3285_IM
GB