Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• After you finish your work, push the laser light on/off button to "O" position to switch
off the laser beam.
e. Dust extraction (Fig. 5)
Fig. 5
f. Changing the blade (Fig. 6)
!
Always wear sturdy gloves when handling or changing blades as they
can be very sharp.
WARNING
Fig. 6
180731_ayce_3285_IM
•
To install the dust extraction tube,
simply insert it onto the tool.
•
To remove it, just pull it out of the tool.
•
For optimum dust extraction, connect
the dust extraction port to a suitable
vacuum cleaner or workshop dust
extraction system.
•
Only use sharp and undamaged saw
blades. Cracked or distorted saw
blades must be replaced immediately.
•
Place the saw on its side on a flat
surface.
•
Rotate the saw blade by hand
whilst depressing the spindle lock
button until the blade locks. Whilst
depressing the spindle lock button,
turn the blade bolt anti-clockwise
using the wrench provided.
•
Remove the outer blade flange and
the blade bolt. Raise the lower blade
guard using the blade guard lever. Remove the saw blade from the inner
flange and pull it out.
• Clean the saw blade flanges thoroughly before mounting the new saw blade. Wipe
a drop of oil onto the inner and outer flange where they will touch the blade.
• Mount the new saw blade onto the spindle and against the inner flange.
Replace the outer flange and tighten the blade bolt.
The direction in which the blade rotates has to be the same as the
!
direction of the arrow marked on the upper blade guard.
Ensure that the spindle lock button is released.
Before using the saw again, check that the safety devices are in good
WARNING
working order.
IMPORTANT: After replacing the saw blade, make sure that the saw blade runs freely
by turning the blade by hand.
Plug the machine into a power supply and run the saw under no load to check that it
runs smoothly before using it to cut any material.
g. Switch on and off (Fig. 7)
Fig. 7
3. Operation for working
Making a Cut
!
The saw blades shipped with this product are for cutting wood. Do
not attempt to saw stone and ceramic tile materials with these
saw blades. Before operation, ensure that the saw blades are free
from damage and properly fitted to the product.
WARNING
Never use the product if the lower guard is not operating properly.
!
Carefully check the lower guard before each use. If the lower
guard does not close or moves freely, have it checked and repaired
by a qualified specialist before using this product.
WARNING
102 103
|
• The tool is equipped with a lock-off
button to avoid unintentional starting.
• To switch on, depress the lock-off
button and squeeze the trigger switch.
To switch off, release the trigger
switch.
CAUTION: Allow the blade to come to a
complete standstill before setting the saw
down.
180731_ayce_3285_IM
GB
Publicité
Table des Matières
