Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the machine and your
purpose.
2. Functions
a. Setting the depth (Fig.1)
Fig. 1
b. Parallel Stop (Fig.2)
Always ensure that the machine is switched off and plug is removed
!
from the power supply before making any adjustment.
WARNING
Fig. 2
•
You can adjust the depth in variables
of 0.2 mm from 0 to 2 mm by turning
the setting knob for the depth.
•
Turn the setting knob for the depth in
a clockwise direction to set a greater
depth.
•
Turn the setting knob for the depth in
a counter-clockwise direction to set a
lower depth.
•
After finishing work, set the depth so
that the blades are lowered and thus
protected from damage.
•
Turn the setting knob for the depth to
position "P" for this purpose.
•
The parallel stop is secured to the
side of the machine by using parallel
stop knob.
•
Adjust the distance from the blade
and secure with locking nut.
NOTE: as it is a guide, make a test cut
•
on a scrap of timber prior to making
any cut on the work piece.
Publicité
Table des Matières
