EXHAUST GAS VOLUME ADJUSTMENT (For Europe)
1
Lg
2
1
2
ENGINE
EXHAUST GAS VOLUME ADJUSTMENT
(For Europe)
TIP
_
Be sure to set the CO density level to standard, and
then adjust the exhaust gas volume.
1. Remove:
• Right side cover
Refer to "COVERS" in CHAPTER 3.
2. Connect a jumper lead 1 to the light green ter-
minal (CO adjustment coupler 2), and then
ground the jumper lead.
3. Turn the main switch off and set the engine stop
switch to "RUN".
4. Simultaneously press and hold the "SELECT"
and "RESET" buttons, turn the main switch on,
and continue to press the buttons for 8 seconds
or more.
TIP
_
• All displays on the meter disappear except the
clock display.
• "dI" appears on the clock LCD.
5. Press the "SELECT" button to select the CO
1
adjustment mode "CO" 1 or the diagnostic
mode "dI".
6. After selecting "CO", simultaneously press the
"SELECT" and "RESET" buttons for 2 seconds
or more to activate the selection.
4
INSP
ADJ