Yamaha RS Venture RST90GTY 2009 Mode D'emploi page 137

Fault code No. 13
Diagnostic code No. d:03 (intake air pressure sensor 1 (cylinders #1, #2, and #3))
Order Item/components and probable cause
1 Connections
• Intake air pressure sensor 1 (cylinders #1,
#2, and #3) coupler
• Wire harness ECU coupler
2 Open or short circuit in wire harness.
3 Defective intake air pressure sensor 1
(cylinders #1, #2, and #3).
FUEL INJECTION SYSTEM
Symptom Intake air pressure sensor 1 (cylinders #1, #2, and #3): open or short circuit
detected.
Check or maintenance job
Check the couplers for any pins that may have
pulled out.
Check the locking condition of the couplers.
If there is a malfunction, repair it and connect the
coupler securely.
Repair or replace if there is an open or short cir-
cuit.
Between the intake air pressure sensor 1 (cylin-
ders #1, #2, and #3) coupler and ECU coupler.
Black/Blue – Black/Blue
Pink/White – Pink/White
Blue – Blue
Execute the diagnostic mode (code No. d:03).
Replace if defective.
1. Connect the pocket tester (DC 20 V) to the
intake air pressure sensor 1 (cylinders #1, #2,
and #3) coupler terminals as shown.
Positive tester probe → Pink/White 1
Negative tester probe → Black/Blue 2
2. Turn the main switch on.
3. Measure the intake air pressure sensor 1 (cyl-
inders #1, #2, and #3) output voltage.
4. Is the intake air pressure sensor 1 (cylinders
#1, #2, and #3) OK?
59
2 1
B/L P/W L
Intake air pressure sensor 1 (cylin-
ders #1, #2, and #3) output volt-
age:
3.75 ~ 4.25 V
FI
Reinstatement
method
Setting the
engine stop
switch to "RUN"
and turning the
main switch on.