Short Description Of The Press Device (Fig. 1) - NovoPress ACO401 Manuel D'utilisation

Rechargeable battery
Voltage
Capacity
Height
Length
Width
Weight
Temperature range
during operation
Information!
The batteries are not charged when delivered.
Therefore
– Charge the batteries before using them for the first time.
Battery charger
For information on the function and operation of the battery charger and the rechargeable
batteries, please consult the Operating Manual provided for the battery charger.
6

Short description of the press device (Fig. 1)

The ACO401 press device comprises the press device (1) and a fixed adaptor jaw (2). The
head with the adaptor jaw can be rotated through 180°. It is only possible to adjust the head
before the pressing operation. The head cannot be rotated while the pressing operation is being
performed.
To carry out the pressing operation, hold the device tightly on handle (3) and on grip (4) on the
adaptor jaw.
6.1 Automatic press cycle
The device features an automatic press cycle. This ensures that the pressing operation is
completed every time. For safety reasons, the automatic press cycle only switches on when the
pressing operation has started, i.e. from when the fitting starts to be shaped.
After the automatic press cycle has been triggered, the green LED (5) goes out and the
pressing operation runs automatically. The pressing operation can then only be stopped by
pressing and holding release button (6). After the pressing operation has been completed, the
motor automatically switches off and the green LED lights up again.
If start button (7) is released before the automatic press cycle begins, the piston in the press
device moves back to its starting position. The pressing operation will not have been completed.
The pressing operation must be triggered again.
18 V DC (lithium-ion)
3.0 Ah
75 mm
120 mm
75 mm
0.68 kg
-10°C to +50°C
21
ACO401
EN