NovoPress ACO401 Manuel D'utilisation page 30

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
ACO401
7.2
Starting position of the press collar (Fig. 5)
EN
The press collar must be positioned in the way shown (oval shape) before it is placed on a
fitting. After the press collar has been opened and removed from a fitting, the press collar must
again be positioned in the way shown.
7.3
Closing the collar (Fig. 6 + 7)
• By pressing the outer end of the shell gently, the shell moves inwards. (Fig. 6)
• Arrow (A) must point to line (B) when the press collar is positioned correctly. (Fig. 7)
Information!
To ensure that the press collars function correctly, the sliding segments must be free
to move.
The sliding segments are always pressed back automatically into the correct starting
position by springs.
Ensure that marking lines (M) on shells (C) and sliding segments (D) are aligned
when the press collar is in starting position. (Fig. 5)
If this is not the case, have the press collars repaired.
CAUTION!
There is a risk that the press collar will break if it is positioned
incorrectly
If the press collar is positioned incorrectly on the fitting the press collar may become
damaged.
Therefore
– Arrow (A) must point to line (B). (Fig. 7)
– If this is not the case, remove the press collar again and reposition it.
24

Publicité

Table des Matières
loading

Table des Matières