NovoPress ACO401 Manuel D'utilisation page 32

ACO401
EN
WARNING!
Risk of injury from ejected fragments
Material fatigue may cause the press tool to break.
Press tools are wearing parts.
Frequent pressing will result in material fatigue. Press tools worn or damaged in any
other way as the result of material fatigue can break even if used correctly; there is
then a risk of injury from ejected fragments. The risk of breakage is further increased
in the event of improper use.
Therefore
– Check the press tools for cracks and other signs of wear before each use.
– Discard all press tools with material cracks or other signs of wear immediately and
do not use them any longer.
– Only use press tools that are in perfect technical condition.
CAUTION!
Danger of crushing!
There is a risk of fingers and hands becoming crushed.
Therefore
– Keep all body parts and foreign objects away from the jaw levers on the fixed
adaptor jaw when initiating the pressing operation.
– Do not hold the jaw levers of the adaptor jaw with your hands during the pressing
operation. Use the grip (4). (Fig. 1)
CAUTION!
Keep fingers away from the at-risk zone when the adaptor jaw is closed.
(Fig. 4a)
Fingers may get crushed.
Therefore
– Leave the adaptor jaw open. (Fig. 4b)
Information!
To ensure that the press collars function correctly, the sliding segments must be free
to move.
The sliding segments are always pressed back automatically into the correct starting
position by springs.
Ensure that marking lines (M) on shells (C) and sliding segments (D) are aligned
when the press collar is in starting position. (Fig. 5)
If this is not the case, have the press collars repaired.
26