Remaining Hazards; Lables And Positions - Jet JOSS-S Mode D'emploi

Do not operate the machine under the influence of
drugs, alcohol or any medication. Be aware that
medication can change your behaviour.
Never reach into the machine while it is operating or
running down.
Never leave a running machine unattended. Before you
leave the workplace switch off the machine.
Keep children and visitors a safe distance from the work
area.
Do not operate the electric tool near inflammable
liquids or gases.
Observe the fire fighting and fire alert options, for
example the fire extinguisher operation and place.
Do not use the machine in a dump environment and do
not expose it to rain.
Wood dust is explosive and can also represent a risk to
health.
Dust form some tropical woods in particular, and from
hardwoods like beach and oak, is classified as a
carcinogenic substance.
Always use a suitable dust extraction device
Before machining, remove any nails and other foreign
bodies from the workpiece.
Never operate with the table insert not in place.
Make sure to guide and hold the workpiece tight
during machining.
Machine only stock which rests securely on the table.
Specifications regarding the maximum or minimum size
of the workpiece must be observed.
Do not remove chips and workpiece parts until the
machine is at a standstill.
Do not stand on the machine.
Connection and repair work on the electrical
installation may be carried out by a qualified electrician
only.
Have a damaged or worn power cord replaced
immediately.
Replace any torn or worn sanding belt immediately.
Make all machine adjustments or maintenance with the
machine unplugged from the power source.
3.3 Remaining hazards
When using the machine according to regulations some
remaining hazards may still exist.
The moving sanding sleeve can cause injury.
Risk of kickback. The workpiece is caught by the moving
sanding sleeve and thrown back to the operator.
Thrown workpiece parts can lead to injury.
Sanding dust and noise can be health hazards. Be sure
to wear personal protection gear such as safety goggles
and dust mask. Use a suitable dust exhaust system.
Defective sanding discs can cause injuries.
The use of incorrect mains supply or a damaged power
cord can lead to injuries caused by electricity.
3.4 Lables and positions
A: Safety warning
B: Spindle rotation direction
C: Spindle lock fully disengaged before running
D: Electrical Shock
E: ID label w/ CE mark
5