Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.
Install hex nut (F) onto spindle threads and tighten
clockwise (as viewed from above) with provided
combination wrench.
9.
Pull on sleeve to ensure it is secure. If it slides,
tighten nut (F) a bit further. Do not overtighten.
10. Release spindle lock (E). Make sure it retracts by
rotating spindle slightly.
Make sure spindle lock has fully
disengaged from spindle before turning on sander, or
damage to motor may result.
To remove a spindle, reverse the above procedure(s).
5.7 Installing table insert
Tools required:
cross‐point screwdriver
straight edge
Failure to use proper table insert
with corresponding spindle/drum may result in
personal injury and/or damage to workpiece.
Table inserts are round or oblong. Table 1 identifies
purpose of each.
Used with spindle
Insert
(diameter)
3" and 4"
1/2", 5/8", 3/4",
1", 1‐½", 2"
1/4" and 3/8"
1/4", 3/8", 1/2", 5/8"
and 3/4"
1", 1‐½", 2"
3" and 4"
Table 1: Table insert identification
1.
Position insert into table, so that notch is captured
by the pin (A, Figure 6).
2.
Place straight edge over insert and table. If gaps
appear between straight edge and insert, turn
screw(s) to raise or lower insert. Reposition
straight edge at right angle to check level in both
directions.
Note: Leveling one insert is sufficient as all inserts are
same thickness.
5.8 Wrench storage
The provided combination wrench has a magnetic strip,
and can be placed against any metal surface.
Expose the adhesive on the additional magnetic strip
and apply anywhere on the cabinet surface. The hex
key can be stored against it.
5.9 Dust collection
A sander produces a significant volume of wood dust;
Table angle
the use of a dust collection system is strongly
recommended. It will help keep the shop clean, as well
0 deg.
as reduce potential health hazards caused by inhalation
of wood dust. The collector should have a capacity
sufficient for this size machine; minimum 20m/sec flow
0 deg.
rate is recommended.
JET has a line of dust collection systems available; see
your dealer or visit our website listed on the cover.
0 deg.
Connect the hose of your dust collection system to the
100mm dust port (Figure 7) at rear of sander. Secure
Up to
tightly with a hose clamp.
45 deg.
Up to
45 deg.
Up to
45 deg.
9
Figure 6: mounting table insert
Figure 7
Publicité
Chapitres
Table des Matières
