10.0 Troubleshooting JOSS‐S Spindle Sander
Symptom
Sander will not start.
Sanding drum does not
come up to speed.
Machine vibrates
excessively.
Sanded edge not square.
Sanding marks on wood.
11.0 Available accessories
Refer to the JET‐Pricelist for various grit sanding sleeves.
12.0 Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be recovered or recycled. Please leave it at a specialized institution.
This symbol indicates separate collection for electrical and electronic equipment required under the WEEE Directive
(Directive 2012/19/EC) and is effective only within the European Union.
Possible Cause
Sander unplugged from wall or motor.
Fuse blown, or circuit breaker tripped in
service panel.
Cord damaged.
Starting capacitor bad.
Extension cord too light or too long.
Low current.
Stand or base on uneven surface.
Bearings worn.
Table not square to sanding drum.
Wrong grit sanding sleeve.
Feed pressure too great.
Correction
Check all plug connections.
Replace fuse, or reset circuit breaker.
Replace cord.
Replace starting capacitor.
Replace with adequate size and length cord.
Contact a qualified electrician.
Adjust stand or base so that it rests evenly on
the floor.
Replace bearings.
Use a square to adjust table to sanding drum.
Use coarser grit for stock removal and fine grit
for finish sanding.
Do not force workpiece against spindle or
drum.
Table 3
13