4. Machine specifications
4.1 Technical data
Table size(LxW)
Table tilt
Spindle speed
Oscillations
Oscillation stroke
Sanding sleeve length
Max. workpiece height
Dust port diameter
suction at 20 m/sec
Overall (LxWxH)
Table height
Net weight
Mains
Output power
Reference current
Extension cord (H07RN‐F):
Installation breaker protection
4.2 Noise emission
Declared emission values according to EN ISO 4871:
A‐weighted sound pressure level (LpA)
Uncertainty
A‐weighted sound power level (LwA)
623x623 mm
45 front, 15 back
1400 rpm
60 /min
38 mm
150‐230 mm
80‐160 mm
100 mm
560 m3/h
623x623x995 mm
995 mm
98 kg
1~230V, PE, 50Hz
0,75 kW (1HP) S1
5.5 A
3x1,5 mm²
10 A
72.9 dB
3 dB
86.1 dB
6
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is
intended to allow the user to make a better estimation
of the hazards and risks involved only.
4.3 Content of delivery
Most of the below items can be found on or inside
sander cabinet. Some items are shipped in the small
box which accompanies the machine. One table insert
comes installed on the table.
Refer to Figure 1.
1 Spindle sander (not shown)
6 Table inserts:
for 4" (100mm) rubber drum (at 90°) – A
for 2" (50mm) rubber drum (at 90°) – B
for 1/4" (6mm) and 3/8" (9mm) spindle (at 90°) – C
for 1/4" (6mm) ‐ 3/4" (19mm) spindle (at tilt) – D
for 1" (25mm), 1‐½" (38mm), 2" (50mm) rubber
drum (at tilt) – E
for 3" (75mm) and 4" (100mm) rubber drum (at tilt) – F
1 Rubber drum with sleeve 4" (100mm) – G
1 Rubber drum with sleeve 3" (75mm) – H
1 Rubber drum with sleeve 2" (50mm) – J
1 Rubber drum with sleeve 1‐½" (38mm) – K
1 Rubber drum with sleeve 1" (25mm) – L
1 3/4" (19mm) sleeve – M
1 3/4" (19mm) Spindle – N
1 5/8" (16mm) Spindle with sleeve – O
1 1/2 " (12mm) Spindle with sleeve – P
1 3/8" (9mm) Spindle with sleeve – R
1 1/4" (6mm) Spindle with sleeve – S
1 Spindle hex nut – T
1 Combination wrench (with magnet strip) – U
1 Hex wrench 3mm, and magnet strip – V
1 Operating manual
1 Spare parts list.
Note: All provided sanding sleeves are 100 grit.
Additional grits are available – see parts breakdown.
Figure 1