Remaining Hazards; Machine Specifications; Machine Description; Technical Data - Jet JDS-12X-M Mode D'emploi

Do not stand on the machine.
Connection and repair work on the electrical installation may be
carried out by a qualified electrician only.
Have a damaged or worn power cord replaced immediately.
Make all machine adjustments or maintenance with the machine
unplugged from the power source.
3.3 Remaining hazards
When using the machine according to regulations some
remaining hazards may still exist.
The moving sanding disc in the work area can cause injury.
Risk of kickback. The work piece is caught by the moving sanding
disc and thrown back to the operator.
Thrown work piece parts can lead to injury.
Sanding dust and noise can be health hazards. Be sure to wear
personal protection gear such as safety goggles and dust mask.
Use a suitable dust exhaust system.
Defective sanding discs can cause injuries.
The use of incorrect mains supply or a damaged power cord can
lead to injuries caused by electricity.
4. Machine specifications
4.1 Machine description
A . ........... M otor
B ............ O n/Off switch
C ............ S anding disc
D . ........... D isc brake
E ............ D isc safety guard
F ............ T able
G . ........... M itre gauge
H . ........... D ust port
I ............. B ase
J ............. M ounting holes (4x)
K ............ T able tilt control and lock knob
4.2 Technical data
Sanding disc diameter
Table size (LxW)
Table tilt
Table tilt stops
Disc speed
Dust port diameter
Suction at 20m/s
Overall (LxWxH)
Net weight
Mains
Motor power
Reference current
Extension cord (H07RN‐F):
Installation fuse protection
Insulation protection class
Fig 1
305 mm
435 x 215 mm
0° ‐ 45
0°; 22,5°, 45°
1430 rpm
57 mm
185 m³/h
450x510x400 mm
34 kg
1~230V, PE, 50Hz
0,75 kW (1HP) S1
4,6 A
3x1,5 mm²
10 A
I