Noise Emission; Contents Of Delivery; Transport And Start Up; Transport And Installation - Jet JDS-12X-M Mode D'emploi

4.3 Noise emission
Acoustic pressure level (according to EN ISO 11202):
Idling
In operation
The specified values are emission levels and are not necessarily
to be seen as safe operating levels.
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards and
risks involved only.
4.4 Content of delivery
Disc brake
Dust collection port 57mm
Abrasive disc, 60 grit
Mitre gauge
Operating manual
Spare parts list.
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate in closed rooms and must be
placed stable on firm and levelled surface.
For safety reasons, the machine must be bolted to the work
bench or to a suitable stand .
Attach a large C‐clamp to each side of the sander and
workbench, or permanently mount with 4 bolts M8 and nuts (J,
Fig 2).
For packing reasons the machine is not completely assembled.
5.2 Assembly
If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Attach the disc brake (D, Fig 3) with two hex socket screws (N).
71,9 dB (A)
84,1 dB (A)
Fig 2
5.3 Mains connection
Mains connection and any extension cords used must comply
with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
This machine must be properly grounded.
The mains connection must have a 10 A surge‐proof fuse.
Only use power cords marked H07RN‐F
Connections and repairs to the electrical equipment may only be
carried out by qualified electricians.
5.4 Dust connection
Before initial operation, the machine must be connected to a
dust collector.
The suction should switch on automatically when the belt sander
is switched on.
Flexible hoses must be of non‐flammable quality, and must be
connected to the dust collector ground system.
5.5 Starting operation
You can start the machine with the green ON‐button (C, Fig 4).
The red OFF‐button (B) on the main switch stops the machine.
After you have turned "OFF" the sander you can press the brake
lever (D) to stop the sanding disc rapidly.
Fig 3