Remaining Hazards; Labels And Positions - Jet JWDS-2244-M Mode D'emploi

Keep an ergonomic body position. Maintain a balanced
stance at all times.
Do not operate the machine under the influence of
drugs, alcohol or any medication. Be aware that
medication can change your behaviour.
Never reach into the machine while it is operating or
running down.
Always close the drum cover before you start the
machine.
Keep you hands distant to drum housing and conveyor
belt when feeding the work piece.
Keep children and visitors a safe distance from the work
area.
Never leave a running machine unattended. Before you
leave the workplace switch off the machine.
Do not operate the electric tool near inflammable liquids
or gases. Observe the fire fighting and fire alert options,
for example the fire extinguisher operation and place.
Do not use the machine in a dump environment and do
not expose it to rain.
Sanding dust is explosive and can also represent a risk to
health.
Always use a suitable dust extraction device.
Before machining, remove any nails and other foreign
bodies from the workpiece.
Work only with well sharpened tools.
Machine only stock which rests securely on the table.
Always close the chuck cover before you start the
machine.
Specifications regarding the maximum or minimum size
of the workpiece must be observed.
Do not remove chips and workpiece parts until the
machine is at a standstill.
Do not stand on the machine.
Connection and repair work on the electrical installation
may be carried out by a qualified electrician only.
Have a damaged or worn power cord replaced
immediately.
Make all machine adjustments or maintenance with the
machine unplugged from the power source.
dispose of the packing in
Protect the environment,
an environmentally friendly manner.
All manuals and user guides at all-guides.com
5
Your appliance contains valuable materials which can
be recovered or recycled. Please leave it at a
specialized institution.
This symbol indicates separate collection for electrical
and electronic equipment required under the WEEE
Directive (Directive 2012/19/EC) and is effective only
within the European Union.
3.3 Remaining hazards
When using the machine according to regulations
some remaining hazards may still exist.
The moving sanding sleeve can cause injury.
Risk of kickback. The workpiece is caught by the
moving sanding sleeve and thrown back to the
operator.
Thrown workpiece parts can lead to injury.
Sanding dust and noise can be health hazards. Be sure
to wear personal protection gear such as safety
goggles and dust mask. Use a suitable dust exhaust
system.
Defective sanding abrasives can cause injuries.
The use of incorrect mains supply or a damaged
power cord can lead to injuries caused by electricity.
3.4 Labels and positions
A: Safety warning
B: Sanding drum & Conveyor belt running direction
C: Loosen table lock before adjusting table parallel
Fig.A Fig.B
Fig.C