Stabilizer Installation - Horizon Hobby Pitts S-2B 50–60cc Manuel D'utilisation

26. Secure a 9-inch (230mm) to the servo lead using a safety
connector.
 Use a 6-inch (150mm) extension for the bottom wing servo.
27. Route the extension through the wing and out the wing root.
28. Secure the servo and cover to the wing using a #1 Phillips
screwdriver and four M2 x 8 sheet metal screws.
29. Thread the plastic rod ends on the 60mm threaded aileron
pushrod. Thread each of the rod ends equally on the threaded
rod. Start with a length of 87mm.
30. Snap the ball into the rod end. Prepare both rod ends at this
time.
EN
31. Remove the tape from the wing and aileron. Secure one of
the rod ends to the outer hole of the control horn using a #2
Phillips screwdriver and an M3 x 10 machine screw.
32. Attach the remaining rod end to the servo arm using an M3
x 10 machine screw, M3 washer and M3 lock nut. Use a
#2 Phillips screwdriver and 5mm nut driver to tighten the
hardware. Adjust the linkage to center the aileron when the
aileron servo is centered.

STABILIZER INSTALLATION

33. Separate the elevators from the stabilizer. Remove the hinges
and set the elevators and hinges aside.
34. Use a hobby knife to remove the covering at the rear of the
fuselage under the fi n, exposing the slot for the stabilizer.
8