Programming The Remote Control - Becker Centronic SunWindControl SWC745-II Notice De Montage Et D'utilisation

Programming the remote control

The central command 1-5 cannot be programmed separ-
ately.
1) Programming the master transmitter
a) Readying the receiver for programming
Follow the Assembly and Operating Instructions for the re-
ceiver.
Operate the programming button on the transmitter using a
suitable cylindrical tool (e.g. a ballpoint pen).
• Switch off the power supply to the receiver for 5 seconds, then switch it
back on.
or
• Operate the programming button or the radio switch of the receiver.
The receiver is now in Programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter whilst in Program-
ming mode until the receiver confirms that programming was successful.
On the display, "Transmit setting" appears
Confirm with OK.
The programming process is now complete.
2) Programming additional transmitters
Press the programming button of the master transmitter until the receiver con-
firms.
On the display, "Transmit setting" appears
Confirm with OK.
Then press the programming button of the new transmitter until the receiver
confirms.
Now press the programming button of the new transmitter again.
The receiver confirms successful programming.
42 - en