Becker Centronic SunWindControl SWC745-II Notice De Montage Et D'utilisation page 40

FABRIC TENSION/TILT
The fabric tension/tilt position is a freely selectable position of the sun protec-
tion system/venetian blind between the retracted and extended end positions.
With this function, you can tension the fabric of your sun protection system.
With the venetian blind, the slats can be tilted.
To do so, press the RETRACT button briefly twice in succession.
WINTER OFF/ON
If the WINTER ON function is activated, no automatic or manual drive com-
mands will be executed.
WIND MONITORING
The threshold value for WIND is preset to 04.
The threshold value can be set to anywhere between 01 (little wind) and 11
(very windy).
The set wind strength is indicated on the display. The value to be set flashes.
If the wind strength is lower than set for 15 mins, drive commands can be ex-
ecuted again.
TEST mode
The TEST mode is activated by adjusting a threshold value. This ends auto-
matically after approx. 15 minutes or as soon as the slide switch is activated. In
TEST mode, the shade function and wind monitoring times are shortened.
Language selection (ENGLISH)
Here you can select your own language.
SUMMER/WINTER
SUMMER/WINTER denotes the automatic summer/winter time adjustment.
Factory setting is ON; the unit adapts automatically.
Function menu
This mode is only intended for trained, specialist personnel.
In the FUNCTION menu you can set the following functions:
• AWNING/VENETIAN BLIND (Selection of the shading solution)
• PROGRAM MODE
• RUNNING TIME
• SHADE TIME/AUTO SHADE TIME
• EXPERT MODE OFF/ON
40 - en