Becker Centronic SunWindControl SWC745-II Notice De Montage Et D'utilisation page 36

Channel selection button
Channel selection is only possible in Operating mode.
Up to 5 channels can be selected using the channel selection button. The indi-
vidual channels are indicated by the corresponding channel indicator lamp
lighting up. If all of the channel indicator lamps light up simultaneously, the
central command can be transmitted.
You can make a note of the programmed channel in the la-
belling field underneath the transparent film.
Channel indicator lamps
A radio signal is indicated by the corresponding channel indicator lamp light-
ing up.
The transmission strength and the radio range decrease as battery power de-
clines. If the channel indicator lamp no longer lights up when a button is
pressed, the battery must be replaced.
Operating mode
On the display, you see the wind or sun setpoint value and the time.
OK button
The displayed values are saved by pressing the OK button in the menu.
+/- buttons
The following operations are possible via + and -.
• Menu ->Modify value
• Automatic mode ->Retrieve information:
∙
+ button ->Next automatic shade time
∙
- button ->Next automatic shade time
MENU button
By pressing the MENU button, you access the menu overview or Operating
mode.
The displayed value is not saved.
36 - en