What To Do If - Becker Centronic SunWindControl SWC745-II Notice De Montage Et D'utilisation

Problem
Drive is not functioning.
No reaction from trans-
mitter after changing
batteries.
BATTERY appears on
the display.
Desired drive is not
functioning.
Sun protection does not
travel to end position.
Automatic drive com-
mands are not ex-
ecuted.

What to do if...?

Cause
Batteries are dead.
Batteries are inserted
incorrectly.
Receiver out of radio
range.
Transmitter is not pro-
grammed in receiver.
Power supply was inter-
rupted for too long.
Batteries are weak.
Incorrect channel se-
lected.
End position not set.
"MANUAL" appears on
the display
Winter setting is set to
ON.
The automatic sun pro-
tection function was in-
terrupted by a manual
drive command.
Remedy
Insert new batteries.
Insert batteries cor-
rectly.
Reduce distance from
receiver.
Program transmitter.
Press the RESET but-
ton.
Check the settings.
Insert new batteries.
Select correct channel.
Set the end position in
the settings menu SUN
END POSITION or TIME
END POSITION.
Set the slide switch to
the opposite position.
Set winter setting to
OFF.
Set the slide switch to
the opposite position
and back again.
55 - en