Function Of The Buttons - Becker TouchControl Instructions De Service

TouchControl transmits on the European radio frequency of
40MHz. The range inside buildings is strongly dependent on the
structural conditions. Walls and ceilings that are thickly clad or
heavily reinforced with steel can result in a reduction in range. If
another device in the immediate vicinity is transmitting at the same
time as the TouchControl, this may result in a reciprocal interfer-
ence effect. If a radio command cannot be identified with certainty,
the integrated automatic safety device will reliably prevent mal-
functions and suppress execution of the command.
TouchControl has 3 buttons, UP, DOWN and STOP or GROUP, as
well as a sliding switch for MANUAL-AUTOMATIC changeover. The
meaning of the buttons depends on the control used.
WindControl awning control
Retract
button
STOP button
Sliding switch
The automatic sunshade
function can be switched on or
off by first activating the sliding
switch and then pressing the
STOP switch.
The batteries supplied must be inserted before use. They should
always be replaced in pairs. The transmitter will also operate with
just one battery, but with a lower transmission capacity. Type of
battery: A23 e.g.: Duracell A23-3LR50 12V
6
Operating Instructions TouchControl
TouchControl

Function of the buttons

Extend
button
Commissioning
VarioControl
integrated radio receiver
UP
button
GROUP button
Sliding switch
The automatic time function
(memory function) can be
switched on or off by first acti-
vating the sliding switch and
then pressing the GROUP
switch.
and drives with
DOWN
button