Publicité
Les langues disponibles
Les langues disponibles
Use the special accessory Resin Remover
Concentrate.
•
When exchanging the table insert, make sure
that the insert is at the same height as the
saw table.
•
Regularly check the saw band for defects.
Replace defective saw bands immediately.
•
Regularly check the saw table insert. Re-
Problem
Motro does not turn on
Motor turns the wrong direction
Saw band wanders or jumps
down
Scorch mark on wood during
work
Saw band jams during work
D GB
If you have problems and cannot resolve them yourself, contact the customer service of the scheppach company.
place worn saw table inserts.
•
Rubber bandage of the band wheels
The rubber bandage on the band wheels
becomes cracked and worn over time due
to the metal saw band. An exact saw band
run is therefore no longer possible. The work
safety and the work process are affected.
Exchange band wheels!
Troubleshooting
Possible Causes
a) No power
b) Switch, capacitor defective
c) Electrical extension cord defective
d) Wrong flex 3~400V Motor
e) Housing cober open (end switch)
Incorrect connection
a) Upper band wheel
b) Saw band guide
c) Wrong saw band
d) Longitudinal fence not parallel to saw band
a) Saw band dull
b) Wrong saw band
c) Wrong cutting speed
d) Longitudinal fence not parallel to saw band
a) Saw band dull
b) Saw band resined
c) Guide badly adjusted
•
Remedy
a) Check mains fuse
b) Have a qualified electrician check it
c) Remove mains fuse, check, exchange if needed
d) Flex 5-poled, at 1,5 mm² cross-section
e) Close housing cover exactly
Change rotational direction at CEE plug
a) Carry out side correction
b) Reinstall
c) Select from scheppach catalogue
b) Adjust longitudinal fence
a Replace saw band
b) Select from scheppach catalogue
c) Adjust cutting speed
d) Adjust longitudinal fence
a) Replace saw band
b) Clean saw band
c) Readjust
14
Obtain replacement band wheels, as well
as all other replacement parts through your
scheppach dealer.
Regularly check the adjustment of the saw
band guide and reset it as needed. To adjust,
remove the saw band guide.
Publicité
