Intended Use - Festool TKS 80 EBS Notice D'utilisation D'origine

2.5 Aluminium processing
When sawing aluminium, the following
measures must be taken for safety reasons:
– Install an upstream residual-current circuit
breaker (RCD, PRCD).
– Connect the power tool to a suitable dust
extractor.
– Regularly clean dust deposits from the mo­
tor housing on the power tool.
– Use an aluminium saw blade.
Wear protective goggles.
2.6 Other risks
In spite of compliance with all relevant design
regulations, dangers may still present them­
selves when the machine is operated, e.g.:
– Touching rotating parts from the side: Saw
blade, clamping flange, flange screw,
– Touching live parts when the housing is
open and the mains plug is still plugged in,
– Workpiece parts being thrown off,
– Parts of damaged tools being thrown off,
– Noise emissions,
– Dust emissions.
2.7 Emission levels
The levels determined in accordance
with EN 62841 are typically:
Sound pressure level
Sound power level
Uncertainty
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
The specified noise emission values
– have been measured in accordance with a
standardised test procedure, can be used
to compare one power tool with another,
– and can also be used for a provisional as­
sessment of the load.
3
The TKS 80 EBS is designed as a transportable
power tool for sawing wood, laminated wooden
panels, non-ferrous metals and plastic.
► When sawing non-ferrous metals, wet,
This power tool may only be used by experts or
instructed persons.
3.1
Only use Festool saw blades that are designed
L = 87 dB(A)
PA for use in this power tool.
L = 102 dB(A)
–
WA
–
K = 3 dB
–
–
–
–
Festool saw blades comply with EN 847-1.
Only saw materials for which the saw blade in
question has been designed.
Saw blades made of high-alloy high-speed steel
(HSS steel) and grooving saw blades must not
be used.
3.2
Only use Festool cartridges that are designed
for use in this power tool.
CAUTION
The emission values may deviate from the
specified values. This is dependent on how
the tool is used and the type of workpiece
being machined.
► The actual load during the entire operating
cycle must be evaluated.
► Depending on the actual load, suitable pro­
tective measures must be defined in order
to protect the operator.

Intended use

NOTICE
SawStop technology is triggered
statically charged or conductive materials,
deactivate the SawStop technology (bypass
mode).
The user is liable for improper or non-in­
tended use.
Saw blades
Saw blade dimensions: 254 x 30 x 2.4 mm
Cutting width > 2.2 mm (corresponds to the
kerf width)
Locating bore, dia. 30 mm
Standard blade thickness < 1.8 mm
Saw blade with chip angle of ≥ 15°
Suitable for speeds of 3500 rpm or above
Cartridges
English
29