Intended Use; Technical Data; Parts Of The Machine; Operation - Festool SYM 70 RE Notice D'utilisation D'origine

CAUTION
The noise emissions during actual use of the
power tool can differ from the declared val­
ues depending on the ways in which the tool
is used especially what kind of workpiece is
processed.
► Identify safety measures to protect the op­
erator that are based on an estimation of
exposure in the actual conditions of use
(taking account of all parts of the operating
cycle such as the times when the tool is
switched off and when it is running idle in
addition to the trigger time).
3

Intended use

The power tool is a stationary unit designed for
sawing strips of wood, plastic, aluminium pro­
files and similar materials. Do not use it to
process other materials, in particular steel,
concrete and mineral materials.
Only use Festool saw blades that are designed
for use in this power tool.
The saw blades must comply with the following
data:
– Saw blade diameter 216 mm
– Cutting width 2,3 mm (corresponds to the
tooth width)
– Locating bore30 mm
– Standard blade thickness1,8 mm
– Saw blade in accordance with EN 847-1
– Saw blade with chip angle ≤ 0°
Festool saw blades comply with EN 847-1.
Only saw materials for which the relevant saw
blade has been designed.
This power tool may only be used by experts or
instructed persons.
The user is liable for damage and acci­
dents caused by improper and non-inten­
ded use.
4

Technical data

Compound mitre saw
Power
Speed (no-load)
Mitre angle Interior angle
Exterior angle
Compound mitre saw
Cutting range Max. strip
Tool spindle dia.
Weight as per EPTA-Proce­
dure 01:2014
5
[1-1]
[1-2]
[1-3]
[1-4]
[1-5]
[1-6]
[1-7]
[1-8]
[1-9]
[1-10]
[1-11]
[1-12]
The specified illustrations appear at the begin­
ning of the Operating Instructions.
6
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the machine's name
plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
SYM 70 RE
must be used.
1150 W
6.1
2700 -
► Unlock the transport safety device [1-1] by
5200 rpm
pulling at the locking pin.
0° - 68°
0° - 60°
height
Max. strip
width

Parts of the machine

Transport safety device
Spindle lock
Speed adjusting wheel
Hexagon socket wrench
On/off switch
Release lever for saw unit
Handle
Pendulum guard
Stop rulers
Saw table
Bracket for bevel
Table top insert

Operation

WARNING

Initial commissioning

English
SYM 70 RE
70 mm
80 mm
30 mm
9.6 kg
19