Safety Warnings - Festool SYM 70 RE Notice D'utilisation D'origine

English
Contents
1 Symbols..................................................... 16

2 Safety warnings.........................................16

3 Intended use..............................................19
4 Technical data........................................... 19
5 Parts of the machine.................................19
6 Operation................................................... 19
7 Settings......................................................20
8 Working with the machine........................ 21
9 Service and maintenance..........................23
10 Accessories............................................... 24
11 Environment.............................................. 24
1 Symbols
Warning of general danger
Read the operating manual and safety
instructions.
Danger area! Keep hands away!
Wear protective goggles.
Wear ear protection.
Wear a dust mask.
Wear protective gloves.
Do not dispose of it with domestic
waste.
Tip or advice
Handling instruction
Safety class II
Electronics: Adjustable speed
Saw blade dimensions
D
a ... Max. cutting depth
a
d
D ... Diameter
d ... Locating bore
Wood
Laminated wooden panels
Aluminium
16
Speed adjusting wheel
Danger area! Do not remain in this
area.
2 Safety warnings
2.1 General power tool safety warnings
WARNING! Read all safety warnings, in­
structions, illustrations and specifica­
tions provided with this power tool. Failure to
follow all instructions listed below may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" used in the safety in­
structions refers to mains-powered power tools
(with power cable) or battery-powered power
tools (without power cable).
2.2 Machine-related safety notices
- Mitre saws are intended to cut wood or
wood-like products, they cannot be used
with abrasive cut-off wheels for cutting
ferrous material such as bars, rods, studs,
etc. Abrasive dust causes moving parts
such as the lower guard to jam. Sparks
from abrasive cutting will burn the lower
guard, the kerf insert and other plastic
parts.
Use clamps to support the workpiece
-
whenever possible. If supporting the
workpiece by hand, you must always keep
your hand at least 100 mm from either
side of the saw blade. Do not use this saw
to cut pieces that are too small to be se­
curely clamped or held by hand. If your
hand is placed too close to the saw blade,
there is an increased risk of injury from
blade contact.
The workpiece must be stationary and
-
clamped or held against both the fence
and the table. Do not feed the workpiece
into the blade or cut "freehand" in any
way. Unrestrained or moving workpieces
could be thrown at high speeds, causing in­
jury.
Danger area! Do not re­
main in this area.