The green
The bench-mounted
LED [2-4] lights
circular saw is ready
to use and is in stand
up constantly.
by mode.
The red
LED [2-5] is not
lit.
The green
Restart protection
LED [2-4] flash
When activating by
es rapidly.
pass mode, the yel
low SawStop switch
(alternating)
was released too ear
The red
ly.
LED [2-5] flash
es rapidly.
fault, press the red
STOP button.
The green
Contact with the saw
LED [2-4] lights
blade in standby.
up constantly.
contact trigger and
The red
wait approx. 5 sec
LED [2-5] flash
onds until the fault is
es rapidly.
rectified.
Or:
Distance between
saw blade and fence
too small.
cutting widths of
≤ 3 mm, use a sup
port ≥ 19 mm.
The green
Cartridge locking de
LED [2-4] is not
vice fault.
lit.
bench-mounted cir
The red
cular saw and check
LED [2-5] flash
the cartridge locking
es slowly.
device.
The green
Saw blade missing or
LED [2-4] flash
too small.
es slowly.
bench-mounted cir
The red
cular saw and insert a
LED [2-5] lights
suitable saw blade
up constantly.
(see section
To rectify the
Remove the
When sawing
Switch off the
Switch off the
3
).
The green
LED [2-4] is not
lit.
The red
LED [2-5] lights
up constantly.
LED status during operation
The green
LED [2-4] flash
es rapidly.
The red
LED [2-5] is not
lit.
The green
LED [2-4] flash
es slowly.
The red
LED [2-5] is not
lit.
The green
LED [2-4] flash
es slowly.
The red
LED [2-5] flash
es rapidly.
LED status in standby or during operation
The green
LED [2-4] is not
lit.
The red
LED [2-5] flash
es rapidly.
English
Replace the car
tridge.
Switch off the
bench-mounted cir
cular saw. If the fault
is still not rectified,
insert a new car
tridge.
Or:
Electronics too cold:
Warming phase at
ambient tempera
tures < 5 °C.
Try starting
again after a few mi
nutes.
The saw blade comes
to a stop.
The SawStop
technology is active
and is triggered upon
contact.
Activated bypass
mode.
Contact with the saw
blade while bypass
mode is activated
The fault is rectified if
the saw blade comes
to a stop.
Workpiece too damp.
Switch off the
bench-mounted cir
cular saw and dry the
workpiece or contin
ue sawing in bypass
mode.
33