6.
TechnicAl deTAilS
6.1.
conditions of use
Fluid temperature:
depends on the material from which the
S020 fitting and the device inserted are
made. Refer to the manual for the device
and the temperature/fluid pressure de-
pendency curve in fig. 7.1. If the ranges
are different, use the most restrictive
range.
Ambient temperature:
depends on the device inserted into the
S020. Refer to the relevant manual.
Pressure classification:
depends on the material from which the
S020 fitting and the device inserted are
made. Refer to the manual for the device
and the temperature/fluid pressure de-
pendency curve in fig. 7.1. If the pressure
classifications are different, use the lowest
classification.
6.2.
certificates available
•
Certificat 3.1, S020 in stainless steel only
•
Certificate 2.2
•
Rugosity certificate
•
Calibration certificate
•
FDA approval (with EPDM seal), S020 in stainless steel only
10
Type S020
Technicaldetails
6.3.
General technical data
6.3.1.
diameters available
The diameters available depend on the finish of the S020 fitting.
Consult the technical data sheets for the S020 fittings and the
device inserted to determine the appropriate DN.
Finish of the S020
T-fittings
Stainless steel welding tabs
Plastic fusion spigots
Screw-on
1)
Saddle
1)
Tab. 6.1 : Diameters available depending on the finish of the fitting
1)
Only for the flow measurement.
English
DN available
DN6 to DN65
DN50 to DN350
DN65 to DN400
DN100 to DN400
DN50 to DN200