4.7
SERIAL INTERFACES AND EXTERNAL CONNECTIONS
The UPS is provided with serial interfaces and external connection facilities for the communication of
the operating status and parameters.
Picture 19 – Position of the serial interfaces of KEOR HPE 60÷160 kVA
NORMAL/BYPASS SELECTOR
SNMP (OPTIONAL): it is used for the external transmission of data via LAN.
COMMON BATTERY: it is used for the communication between in common battery
configuration
RS232/USB: it is used for connection to the proprietary programming and control
software.
MODBUS (OPTIONAL): it is used for the transmission of data to the outside via MODBUS
RTU protocol (RS485).
THERMAL PROBE: it is used to acquire the temperature of the battery cabinet/room in
order to adjust the charging voltage automatically.
SRC-2: relay card, used for the remote signalisations of status and alarms.
PARALLEL (OPTIONAL): it is used for communication between paralleled UPS units.
44
OML46086 REV. I
Installation and start-up of KEOR HPE UPS 60÷160 kVA
Installation et démarrage de l'ASI KEOR HPE 60÷160 kVA
Installazione e avviamento KEOR HPE UPS 60÷160 kVA