Publicité
IV - SEALING OF MOUNTING SURFACES
For all mounting surfaces used INSTAJOINT 510 LOCTITE
Product caracteristics
- Colour : orange red
- Adhesive power : weak, nevertheless do not use on centering only on the faces.
- Temperature : resistance - 55°C to + 200°C
!
- TO BE USED WITH CARE : avoid any contact with eyes and skin and do not smoke.
Disassembly
- Disassemble the units : in the event of sticking, tap the parts to break the loctite film.
- Remove particles of loctite as thoroughly as possible and degrease.
Assembly
- Clean and carefully degrease surfaces (the lubricant prevents polymerisation therefore making the
product ineffective) using a solvent or by washing the parts.
- Leave to dry.
- Apply a single beading of Loctite 510 to one of the bearing surfaces well around the attachment
holes (thickness of beading : 1 mm max.)
- Assemble the parts and tighten to the required torque.
- Leave to dry : can be handled after 30 min.- time for complete polymerisation : 18 h to 24 h
NOTA :
To reduce polymerisation time, spray LOCQUIC N activator on to one of the faces, allow to
evaporate and then apply Loctite 510.
All screws shall be tightened within 5 minutes following assembly of the parts : the unit can be
used 10 minutes after assembling.
V - FASTENING
For screws no microcapsuling or re-use after removal used LOCTITE Frein filet SR 242.
Product caracteristics
- Colour : pale blue
- Temperature : resistance - 55°C to + 150°C
!
- TO BE USED WITH CARE : avoid any contact with eyes and skin and do not smoke.
Disassembly
- Disassemble the units, in case of lock, heat the screws
- Clean excess material off the surface and degrease
Assembly
- Clean and carefully degrease surfaces (the lubricant prevents polymerisation therefore making the
product ineffective) using a solvent or by washing the parts.
- Let evaporate.
- Apply on the thread, if possible at the end of the screw, only one drop of the Loctite frein filet.
- To reduce polymerisation time, spray LOCQUIC T activator on the thread,let evaporate and then
apply Loctite frein filet.
- Assemble the parts and tighten to the required torque.
- All screws mustl be tightened as soon after assembly as possible.
- Immediate starting.
Tightening torque
The tightening torques indicated in this manual must be respected.
A tightening torque weaker than indicated may lead to a shearing stress and may break the bolt.
A stonger tightening torque may lead to a plastic deflection of the bolt and damage of the parts.
BT232-12/08
- 7 -
Section 1
Préliminary
Publicité
