Add To Scan; Scan Revert - Kenwood TK-2180 Mode D'emploi

A S
DD TO CAN
Press and hold the key programmed as Scan Delete/Add, to
add or remove each zone or group ID/ channel to or from the
scan sequence.
• The zone add indicator (
when the selected zone is added to the scan sequence.
• The channel/ group ID add indicator (
on the display when the selected channel/ group ID is added to the
scan sequence.
S R
CAN EVERT
You can select Revert zones and channels/ group IDs using
the selector and the Zone or CH/GID keys.
Eight types of Scan Reverts which can be programmed by your
dealer are available.
• Last Called Revert: The last zone/ group ID received is assigned
as the new revert zone and group ID.
• Last Used Revert: The last zone/ group ID responded to is
assigned as the new revert zone and group ID.
• Selected: The last zone/ group ID selected is assigned as the new
revert zone and group ID.
• Selected + Talkback: If the zone/ group ID has been changed
during Scan, the newly selected zone/ group ID is assigned as the
new revert zone and group ID. The transceiver "talks back" on the
current receive group ID.
• Priority 1/ Priority 2: If your dealer has programmed a Priority
channel (either Priority 1 or Priority 2), this channel is the revert
zone and channel.
• Priority 1 + Talkback/ Priority2 + Talkback: If your dealer has
programmed a Priority channel (either Priority 1 or Priority 2), this
channel is the revert zone and channel. The transceiver "talks
back" on the current receive channel.
Note: "Priority" and "Priority + Talkback" are not available for
Trunking Systems.
26
) will appear on the display
) will appear