Registering Sub Unit To Base Unit - Kenwood WD-K10PBS Guide De L'utilisateur

G [All Call] key
Press and hold to make an All Call.
Any function can be configured to the [All Call] key. The unit may
●
come with a different function for this key. For details, please
consult the authorized dealer or installer.
H Power key
Press and hold to turn the power on/off. Press to check the remaining
capacity in the battery. The battery charge LED blinks.
I Microphone
When making a call without using the clip microphone, speak into this
microphone.
This key is disabled when a clip microphone or headset which is
●
sold separately is connected.
J Microphone/ Earphone jack
For connecting a clip microphone, earphone or headset which is sold
separately. Do not connect any device other than the compatible
models.
K Battery Charge LED
Indicates the charging status.
Light up: Charging in progress
●
Blinking: Charging in preparation, or charging error
●
Light goes off: Charging complete
●
L [J]/ [K] key
For adjusting the receiver volume level. The receiver volume changes
with each press of the [J]/[K] key, from level 1 to 15. For details, refer
to "ADJUSTING THE RECEIVER VOLUME LEVEL".
M Data setting connector
For registering this unit to the system or changing the settings.
Normally not used. Do not open the cover. And do not touch the
●
connector.
N Charge contact terminal

REGISTERING SUB UNIT TO BASE UNIT

This unit is used when the transceiver to be used as a sub unit is
registered to the Portable base WD-K10PBS or Base Station WD-
K10BS that is to be used as the base unit.
This section explains on how to register the sub unit to the base
unit (Portable base WD-K10PBS).
18