Scan; Selecting A Scan Resume Method; Band Scan; Memory Scan - Kenwood TH-D74A Guide De L'utilisateur

SCAN

Scan is a useful feature for hands-off monitoring of your
favorite frequencies. Becoming comfortable with all types of
Scan will increase your operating effi ciency.

SELECTING A SCAN RESUME METHOD

The transceiver stops scanning at a frequency or Memory
channel on which a signal is detected. It then continues
scanning according to which resume mode you have
selected. You can choose one of the following modes.
Time-Operated mode
The transceiver remains on a busy frequency or Memory
channel for approximately 5 seconds, and then continues to
scan even if the signal is still present.
Carrier-Operated mode
The transceiver remains on a busy frequency or Memory
channel until the signal drops out. There is a 2 second delay
between signal drop-out and scan resumption.
Seek mode
The transceiver remains on a busy frequency or Memory
channel even after the signal drops out and does not
automatically resume scanning.
1 Access Menu No. 130.
Note:
◆ In digital (DV/DR mode), access Menu No. 131.
2 Set the Scan Resume mode to [Time] (Time-Operated),
[Carrier] (Carrier-Operated) or [Seek] (Seek).
Time-Operate Resume Time
Set the hold time for the Time-Operate scan method.
When a signal is received, scan will pause at that frequency
for the duration of the hold time you set. When the set time
elapses, scan will resume (even if the signal is still being
received).
1 Access Menu No. 132.
2 Set the resume time to [1] ~ [10] sec.
Carrier-Operated Resume Time
Set the hold time for the Carrier-Operate scan method.
When a signal is received, scan will pause at that frequency.
When the signal stops, scan will resume after the duration of
the hold time you set.
1 Access Menu No. 133.
22
2 Set the resume time to [1] ~ [10] sec.

BAND SCAN

Band scan monitors all frequency range that is stored in
Menu No. 100 (Programmable VFO), using the current
frequency step size.
1 Select your desired operation band and frequency.
2 Press [VFO] (1s).
Band scan appears and scan starts at the current
frequency.
• The 1 MHz decimal point blinks while scanning is in
progress.
3 To quit band scan, press [VFO].

MEMORY SCAN

Use memory scan to monitor all Memory channels
programmed with frequency data.
1 Press [MR] (1s).
Scan starts at the current memory channel.
2 To quit memory scan, press [MR].
Note:
◆ At least 2 Memory channels must contain data and must not be
locked out of scan.