Scan - Kenwood TK-2180 Mode D'emploi

If the Scan function is programmed, zones or channels can be
scanned by pressing the key programmed as Scan. Scan can
be used as either Single Scan, Multi Scan, or List Scan.
• Single Scan monitors only the channels of the currently selected
zone, which have been added to the scanning sequence. If set
up to scan Priority channels, the Priority channels will be scanned
even if they are not within the currently selected zone.
• Multi Scan monitors all channels of every zone, which have been
added to the scanning sequence.
• List Scan monitors all channels within the specified range of zones,
which have been added to the scanning sequence. If set up to
scan Priority channels, the Priority channels will be scanned even if
they are not within any of the zones in the list.
To activate Scan, press the key programmed as Scan.
• The icon and "
number appear on the display.
• The zone add indicator (
when the selected zone is added to the scan sequence. The
channel/ group ID add indicator (
the display when the selected channel/ group ID is added to the
scan sequence.
• When a call is received, scanning stops and the zone and channel/
group ID digits appear. Press the PTT switch and speak into the
microphone to respond to the call. The transceiver will continue
scanning after a predetermined time delay if the PTT switch is
released and no further signal is received.
To stop scanning, press the Scan key again.

SCAN

" or the revert zone and channel/ group ID
) will appear on the display
) will appear on
25