Kenwood TK-2180 Mode D'emploi page 40

■
T
RANSMITTING
1 Select your desired zone and group (or zone and
channel).
2 Press the key programmed as Status to enter Status
Mode or Selcall + Status to enter Selcall Mode.
• When using the Status key to enter Status Mode, the
target Fleet/ ID is fixed and cannot be selected. Skip to
step 5 to continue.
3 In Selcall Mode, rotate the selector or press the <B and
C> keys to select the ID of the station you want to call.
• If Manual Dialing is enabled, you can enter digits by using
the DTMF keypad or by selecting digits with the selector.
When using the selector, rotate it to select a digit, then
press the C> key to accept the digit and shift the cursor to
the right. Repeat this process until the entire ID is entered.
4 Press the S key to enter Status Mode.
5 Rotate the selector or press the <B and C> keys to
select the status ID you want to transmit.
• If Manual Dialing is enabled, you can enter digits by using
the DTMF keypad or by selecting digits with the selector.
To enter manual input mode, first press and hold the S
key. When using the selector, rotate it to select a digit, then
press the C> key to accept the digit and shift the cursor to
the right. Repeat this process until the entire ID is entered.
6 Press the PTT switch or Side 2 key to initiate the Status
call.
• "
successfully transmitted.
■
R
ECEIVING
The icon will flash and a calling ID or text message will
appear when a Status call is received.
Press any key to return to Normal Operation Mode.
30
" is displayed when the call has been