Emergency Calls - Kenwood TK-2180 Mode D'emploi

If your transceiver has been programmed with the Emergency
function, you can make emergency calls.
Note: Only the Auxiliary (orange) key and the PF1 (Programmable
Function) key of the optional speaker/ microphone can be
programmed with the Emergency function.
1 Press and hold the key programmed as Emergency.
• Depending on the delay time programmed into your transceiver,
the length of time you must hold the Emergency key will vary.
• When the transceiver enters Emergency mode, the transceiver
will change to the Emergency channel and begin transmitting
based on how the transceiver is set up by your dealer.
Transmit periods are also set by your dealer.
2 To exit Emergency mode, press and hold the Emergency
key again.
• If the Emergency mode completes the preset number of cycles,
Emergency mode will automatically end and the transceiver will
return to the channel that was in use before Emergency mode
was entered.
Note:
◆ Your dealer can set the transceiver to emit a tone when
Emergency mode starts and stops
◆ Your dealer can set the transceiver to emit tones and received
signals as normal or mute the speaker during Emergency
operation.

EMERGENCY CALLS

37