Programming The Transmitter - Becker Centronic VarioControl VC470-II Notice De Montage Et D'utilisation

Programming the transmitter

1. Connect the radio receiver to the power supply.
2. Now switch on the power.
3. The radio receiver remains ready for programming for 3 minutes.
Programming the master transmitter
The master transmitter refers to the very first transmitter
programmed in a receiver. In contrast to subsequently pro-
grammed transmitters, the master transmitter enables,
among other things, the setting of limit positions (for drives
with integrated radio receiver) and the programming or de-
leting of further transmitters. Any transmitter that has separ-
ate UP, STOP, DOWN buttons and a programming button can
be a master transmitter.
If a transmitter is already programmed in the receiver, press
the programming button of the transmitter for 10 seconds.
Press the programming button of the transmitter for 3 seconds whilst in pro-
gramming mode.
► The receiver confirms programming, i.e. the shading solution moves a
few centimetres before reversing the same distance.
The programming process is now complete.
23 - en