Deleting Transmitters - Becker Centronic VarioControl VC470-II Notice De Montage Et D'utilisation

Information for the operation of the Venetian blind
If an intermediate position II has been saved, this is done
after approaching intermediate position I. If an intermediate
position I has not been saved, this is done after the running
time has elapsed.
Deletingindividual transmitters
The programmed master transmitter cannot be deleted. It
can only be overwritten.
Press the programming button on the master transmitter for 3 seconds.
▻ The receiver confirms.
Now press the programming button of the transmitter to be deleted for 3
seconds.
▻ The receiver confirms.
Then press the programming button of the transmitter to be deleted again for
10 seconds.
▻ The receiver confirms.
► The transmitter is now deleted from the radio receiver.
Deleting all transmitters (except the master
transmitter)
Press the programming button on the master transmitter for 3 seconds.
▻ The receiver confirms.
Re-press the programming button on the master transmitter for 3 seconds.
▻ The receiver confirms.
Re-press the programming button on the master transmitter for 10 seconds.
28 - en

Deleting transmitters